Tool Use And Care; Service; Operation Instructions - Urrea Boroscopio Flexible Simple Manual De Usuario

TOOL USE AND CARE

• Do not force electronic equipment. Use the
correct tool for the application. The correct
tool will do the job better and more safely at
the rate that it was designed to work at.
• Use clamps or other practical way to secure
and support the workpiece to a estable plat-
form. Holding the work by hand or against your
body is unestable and may cause loss of control.
• Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled whith the
switch is dangerous and must be repaired.
• Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the equipment.
• When the electronic equipment is not in use,
store it out of the reach of children, and do not
allow individuals who are not familiar with the
electronic equipment or these instructions to
operate it. Electronic equipment are danger-
ous in the hands on untrained users.
• Use the electrical device and accessories in
accordance with these instructions, taking into
account the working conditions and the work
to be performed.
• Use the electrical device and accessories in
accordance with these instructions, taking into
account the working conditions and the work
to be prformed.
• NEVER use this instrument for medical use.
• Use of the electrical device for operations
different from those intended could result in a
hazardous situation.
• Is recommendable to use a safety device suit-
able, such a thermal and diferential switch
when you are using an electric equipment.

SERVICE

• Tool service must be perfomed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
• When tool service is required, use only identi-
cal replacement parts and follow the instruc-
tions from Maintenance Section in this manual.
The use of unauthorized parts or failure to fol-
low Maintenance Instructions may cause a risk
of electric shock or injury.
ATTENTION
Only use this instrument as indicated in this instruc-
tion manual. No warranty will be applicable in case
of misuse of the instrument. We will not be liable
for consequences inherent to damage.
OPERATING INSTRUCTIONS
ATTENTION
To reduce the risk of serious injury during use,
follow these instructions.
• Do not expose to excessive heat. Never store
them in the glove compartment of a vehicle
during the summer or place it near a fire or a
hot surface. Even the hot sunlight, direct can
cause explosion.
• When loading batteries, make sure the
borescope is off, follow the + and - sym-
bols inside the battery
• If the tool is not used for more than two
weeks, remove the batteries and store in a dry
place at 20 ° C (68 ° F) or less.
• Battery Power tends to weaken as the tem-
perature drops. Also weakened after intensive
use, gradually recovering after a short break.
Energy decreases gradually when not in use
for a long time. Check the status of the bat-
tery before use, replace the batteries with a
new set before they are completely exhausted.
• Battery performance may vary with each
compartment.
7