Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
You will need
To assemble this product (these items not supplied)
Safety
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or
performing any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
To prevent injuries, do not allow children to play under the product during assembly.
Do not climb or stand on the roof.
Some versions of this product are painted.
If color was scratched during assembly it can be fixed with the following tints:
White – RAL 9016
Before Assembly
This product is suitable for Palram's Patio Covers range
Please consult your local authorities if any permits are required to construct the product.
It is highly recommended to be assisted by a second person in some steps.
Sort the parts and check according to the contents parts list.
This product is suitable for Palram's Patio Covers range
This product must be assembled on a solid base (such as concrete or asphalt)and anchored
to the ground.
Choose your site carefully before beginning assembly. Make sure that the mounting surface is
leveled and clean from sharp objects in order to prevent scratches or damages to the product.
Prior to the Extention installation, several parts from the Patio cover needs to be dismantle,
it is recommend to keep them in a safe place for future need.
x2
8mmo
During Assembly
These instructions mainly refer to the assembly of the SideWall on the right
side of the patio cover. Assembly of the SideWall on the left side of the patio
cover is possible taking the same steps.
In several steps "Option 1" or "Option 2" notifications represent the
assembly side selection. "Option 1" refers to assembly on the left side while
"Option 2" refers to the right.
While mounting the frame structure to back wall or floor the application of
silicone sealant is needed in order to ensure maximal sealing.
Step 3 : Please follow "Option 1" or "Option 2" according to the side you chose
to mount the SideWall.
Step 4 : Please attach #7463 with part #7482 already attached to the wall.
Step 6 : please attach part #7482 with #7463 as illustrated in drawing 6a.
Step 7 : It is important to assemble the holes outwards in order to allow the
water draining out.
Step 20 : Please follow "Option 1" or "Option 2" according to the side you
chose to mount the SideWall.
Use part #7514 when installing the SideWall on the left side of the patio cover.
Use part #7485 when installing the SideWall on the right side of the patio cover.
Step 21 : Please follow "Option 1" or "Option 2" according to the side you
chose to mount the SideWall.
Step 36 : Application of silicone sealant is possible if necessary.
Step 39 : It is possible to trim the panel to desired size if needed.
Step 41 : Please insert the sealing rubber (#7473) at the same time; on both
sides of the panel as described in drawing 41b.
Step 45 : Please use the leftovers of sealing rubber (#7473) from step 41.
Publicidad
