Chauvet Green Thinking Q-Wash 560Z-LED Guía De Referencia Rápida página 3

EN
Replacing
the Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
1. Disconnect this product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the safety cap and replace with a fuse of
the exact same type and rating (F5 220V).
5. Insert the fuse holder back in place and reconnect power.
The Q-Wash™ 560Z-LED will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The Q-Wash™ 560Z-LED uses a regular DMX data connection for its
DMX personalities: Basic, Advanced, and G1. See the User Manual to
connect and configure for DMX operation.
The Q-Wash™ 560Z-LED uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Overhead Mounting
Q-Wash™ 560Z-LED QRG
Safety Cable (Included)
Omega Bracket (Included)
Floor Mounting
3