Publicidad
3
Lift the right panel upright (again, do not move it past
vertical).
5
Lift the compartment side upright, while keeping the
compartment top in position; insert the dowel in the end
of the top into the hole in the right side.
7
Push the two C Casters without Brakes into the rear
sockets on the underside of the Bottom Panel. Push
the two D Casters with Brakes into the front sockets.
9
Install the F Printer Shelf:
lift the back rollers on the
Shelf Rails over the front
rollers on the lower set of
cabinet rails, tilt the Shelf
enough to start the Shelf
moving, and lower the
shelf to push it all the way
into place.
1901-37: 2 of 2; 05/02
D
C
F
Safco Products Company, New Hope, MN 55428
4
Lift the compartment top upright.
6
Push the B Bottom Panel into place so its clips fully
engage the studs on the side panels.
8
Carefully set the
unit upright, and
position the E
Top Panel over the
unit. Press down
until the clips snap
over the studs.
10
Install the G Keyboard Shelf onto the upper rails
in the same manner. Remove the paper backing
from the H Wrist Rest, and carefully position it
above the left front edge of the Keyboard Shelf (it
cannot be moved once in place). Attach perma-
nently by pressing firmly.
G
B
E
H
Publicidad
