Scope Of Delivery; Technical Data - REV ANGLE LIGHT 55 Manual Del Usuario

• Do not operate the product's buttons with electrically conductive objects!
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• To avoid damage, do not bend or knot cables over sharp edges or corners!
• Only connect devices up to max. 24W total power!
• Never combine more than the three products contained in the delivery.
• Note the cable length of the products (approx. 1,5m) and the power supply unit.

SCOPE OF DELIVERY

Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Mounting material (Screws, retaining clips)
• Instructions
• Power supply unit
• Accessories (Connection cable)

TECHNICAL DATA

• Output: 10W LED
• Illuminant: 60 SMD LED´s
• Luminous flux: max. 730lm
• Light output: max. 73lm/W
• Nominal values: 230V~; 50Hz
• Colour temperature: 3000K-6500K
• Colour rendering index (Ra/CRI): ≥ 80
• Energy efficiency class: A
• LED service life: 25000h
• Beam angle: 120°
• IP protection class: IP20
• Protection class: III (S9)
• Ambient temperature: 0°C - 35°C / max. 35°C
• Dimensions W x H x D: 550 x 44 x 25mm
• Coverage angle: 5°
• Coverage area: max. 5cm
• Standby consumption: 0,3W
• Dimming mode: 25% / 50% / 75% / 100% adjustable in 4 steps
• Power supply unit: 230V~; 50Hz; 0,5A // Output: 12V AC; 2A; 24W // Protection class: II (S8)
INSTALLATION (B2)
• Please refer to the drawings for the installation steps.
FUNCTION (C3)
• On/Off: wipe over the sensor at a distance of max. 5cm
• Dimming: briefly tap the area next to the sensor until the desired dimming level is reached
• Colour change: tap long on the area next to the sensor until the desired colour temperature is reached
• Memory function: the last selected setting is available again the next time you switch on
• If you connect a second under-cabinet light of this type via the connecting cable, you can adjust and control both
lights separately and independently.
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
GB
10