Publicidad
Idiomas disponibles
Idiomas disponibles
Rolling Flat Joints
Ensure creaser wheel is in stowed position. Lock in place by pulling forward on creaser hook. The hook should
snap into place.
For verticals:
Advance tape once. Place front roller firmly against wall and roll upward (tape spool should be
to the left of the operator). Maintain a 45° to 90° angle between taper and wall. This prevents
creaser wheel from contacting wall. Approximately 4" from the end of the seam stop rolling and
cut tape. Roll out remainder of tape.
For horizontals:
Same as above. It is recommended that taping be done from left to right (with the tape roll on
top). This allows tape to seat better on tape spool.
Rolling Corner Joints
Ensure creaser wheel is in forward position.
For verticals:
Advance tape twice. Place creaser wheel firmly into corner and roll upward (tape spool should be to
the left of the operator). Maintain centering in corner. This allows even adhesion of tape on both walls
as well as prevents the sides of the creaser wheel from contacting the walls. Approximately 6" from
the end of the seam stop rolling and cut the tape. Roll out remainder of tape.
For horizontals:
Same as above except: Use tape holder wheel to keep tape against creaser wheel when starting
each seam. The tape holder wheel must be cleared away from the creaser wheel before advanc-
ing tape to prevent any interference. As before, it is recommended that taping be done from left
to right.
Maintenance
To clear jam or misfeed:
If tape does not feed within 3 to 4 advances, or the control tube is very tight during advance,
a jam is likely. Open jaw assembly and pull tape through until unaffected portion of tape is past
the cutter mechanism. Close jaw and cut tape to remove damaged portion.
Cleaning and Lubrication:
Adhesive buildup may occur on creaser wheel and/or front roller.
Clean and lubricate daily. WD-40 ® is recommended.
Revised 12.03
Monster Mesh
Encintadora Automática
Guía De Uso y Mantenimiento
Operation and Maintenance Guide
"Roll WithThe Gold"
"How Professionals Finish The Job"
Taper
™
©2003 TapeTech Tool Co, Inc. All Rights Reserved
Publicidad
