Axis P3905–RE Guia De Instalacion página 10

AXIS P3905–RE Network Camera
Note
• The Status LED can be configured to be unlit during normal
operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Status LED can be configured to flash while an event is
active.
• The Status LED can be configured to flash for identifying the
unit. Go to Setup > System Options > Maintenance .
• The Network LED can be disabled so that it does not flash when
there is network traffic. To configure, go to Setup > System
Options > Ports & Devices > LED. See the online help for more
information.
Connectors and Buttons
For specifications and operating conditions, see page 11 .
Network Connector
The Axis product is available in two variants with different network
connectors:
RJ45 Ethernet connector with Power over Ethernet (PoE).
D-coded M12 connector with Power over Ethernet (PoE).
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical
conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting
the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their
specific use. Make sure that the network devices are installed in
accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility
(EMC) on page 2 .
10