Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for Commercial Garment Rack #9550KD
WARNING
1. Please follow the step-by-step assembly instructions.
2. Keep top cross bar horizontal when in use.
3. Do not use rack for anything other than its intended use.
4. Do not allow children to hang from or ride on garment rack.
5. Keep away from heat sources such as heaters and fireplaces.
1
On each base, pull
the center rod upright,
parts 3A + 3B, until
the vertical lock
buttons on the base
click into place.
2
Align both halves of the base, and join,
as shown.
Click!
3A
5
4
5
4
To select the
2
height, click the pin
Insert the top
in rods, parts 2, into
vertical rods,
the correct holes on
parts 2, to the
rods, parts 3A + 3B,
lower vertical
locking the vertical
rods, parts 3A,
rods in place.
3B, at both
sides.
3A
3A , 3B
Click!
3B
5
4
3
Using a screwdriver, secure
the two clamps to the bottom
support. Insert the screw,
part 5, through the clamp,
part 4 and into the pre-drilled
holes on the support.
2
Click!
3B
Click!
For Assistance or Parts Call 1-800-446-3880
6. This product was designed for indoor use.
7. Do not overload one garment rack rod compared
to the other. It is important to maintain some weight
balance to prevent the rack from tipping. 150 lbs.
maximum distributed evenly.
5
Join both ends of the garment
rod, parts 1A + 1B, in the center.
The pin on one end should click
into the hole on the other end,
locking the pieces together.
1A
6
Insert the garment
rod, parts 1A + 1B, into
the top upright
rods, parts 2, at
both sides.
2
3A
To store: Remove the garment rod,
parts 1A+1B, from the top vertical rods
parts 2. Then push in the vertical
lock buttons on the base to release
vertical rods and collapse
(see step 1)
1B
Click!
1A+1B
2
Click!
3B
Place the garment
rod in the clamps,
parts 4.
Publicidad
