Installation - HOMEDEPOT Glacier bay VT3322AA0 Instrucciones De Montaje

Installation

1
Preparing the countertop
Center the template (B) on the counter so that it is parallel to the

counter edge and that the installation hole will not interfere with the
structure of the cabinet.
Tape the template (B) to the countertop to keep it in place and trace

the cutout line on the template (B) with a pencil.
B
3
Preparing the sink
Place the sink (A) into the installation hole to verify the fit. Adjust the cutout if necessary.

Place the sink (A) upside down and align the bottom edge with waterproofing strip.

Install the strainer assembly as these steps describe. It is easier to install the strainer assembly to the sink before the sink is installed to the cabinet.

1) Apply a small amount of plumber's putty (not included) in the notch around the drain hole of the sink (A).
2) Place the strainer ring (E) on top of the drain hole in the sink (A).
3) Insert the screener (C) into the bowl (D) and place this assembly into the drain hole in the sink (A).
4) From underneath the sink (A), place the rubber washer (F), paper washer (G), locknut (H), plastic joint (I), and connecting nut (J) over the drain hole
in the sink (A).
5) Tighten the locknut (H) and connecting nut (J) to hold the strainer assembly securely in place.
A
2
Cutting the installation hole
Drill a pilot hole and cut the countertop opening. Use the

appropriate cutting tool for the surface you are cutting.
C
E
F
H
J
5
Please contact 1-855-HDGLACIER for further assistance.
I
D
I
J
J
K
K
L
L
G
M
M
N
N
I
HOMEDEPOT.COM/GLACIERBAY