Hunter Care Free Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting the Desired Humidity
NOTE: After unplugging the humidifier to
move the humidifi er, to refi ll the water tank
or to clean the humidifi er, you must reset the
digital humidistat.
Refer to Figure 4.
1. Use the power/speed control knob to
turn the humidifi er 'ON' by selecting a speed
setting.
NOTE: A speed setting must be chosen be-
fore the humidistat will operate the humidi-
fi er.
2. In normal mode use the humidistat
control buttons to set the desired humidity
level. The settings range from 30% to 80%
in 5% increments.
3. When the humidity exceeds the level
you have set, the humidistat light will go
off. The humidifi er will not output humid-
ity while the humidity in the room is at the
selected humidity level. The humidistat light
will stay off until the humidity changes.
When the humidity in the room drops be-
low the selected level, the humidifi er will
cycle on again and the humidistat light will
come on.
Humidistat
Light
Humidistat Control
Buttons
Figure 3
41744-01 04/27/2006
41744_booklet_04-27-06.indd 6
Using Your Digital Humidistat
Setting the Span
Refer to Figure 5.
Your humidistat is set at the factory to cycle at
setting 2. If you fi nd your system cycling too fast
or too slow, then the span can be adjusted to
modify the cycle time.
4. Press and hold both humidistat control
buttons for two seconds to enter span set-
ting mode.
5. In span mode, use the humidistat
control buttons to adjust the span. Raise
the span to 3 to increase the cycle time and
allow your system to run longer. Lower the
span to 1 to decrease the cycle time and
allow your system to run shorter.
6. The humidistat display will return to nor-
mal mode after keys are idle for 5 seconds.
Humidistat Control
Buttons
Figure 4
6
©2006 HUNTER FAN CO.
4/27/06, 9:09:00 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido