Technical Specifications; Maintenance And Storage - KRATOS SAFETY FA 60 007 00 Manual De Instrucciones

Chemical products: do not use the device in the event of contact with chemical products, solvents or fuels that could affect its operation.

TECHNICAL SPECIFICATIONS:

Material: Tensioner: Steel. Strap: Polyester.
Weight: 3.43 kg
Static resistance of the system > 19kN.
KRATOS SAFETY certifies that this Type C anchorage device has been tested in accordance with standard EN 795:2012.
COMPATIBILITY FOR USE:
The equipment is for use with a fall arrest system as defined in the product data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is no greater than 6 kN. A fall arrest harness (EN361) is the only body support device that may be used. It can be
dangerous to create one's own fall protection system in which each safety function can interfere with another safety function. Therefore, it is important
to read the recommendations on using each component in the system before use.
INSPECTION:
The recommended service life of the equipment is 10 years, but it may be increased or reduced according to use and/or the results of the annual
inspections.
The equipment should be inspected if there is any doubt, or following a fall and at least annually, by the manufacturer or a competent person, and in strict
compliance with the manufacturer's periodic review procedures (particularly Inspection guides ref. GI XX- XXXXXX-XX), to check its strength and
hence the user's safety. The results of the periodic inspection must be recorded in the ENTECH01 inspection report (downloadable from our website).
We recommend that routine inspections are documented using an inspection report and photographs. The "Equipment identification sheet" should be
completed (by writing) after each verification; date of inspection and date of next inspection must be indicated on the "Equipment identification sheet",
it is also recommended to put date of next inspection on the product.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
MAINTENANCE AND STORAGE: (These instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and keep it in its packaging. Clean with water, wipe with a cloth and hang in
a ventilated room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have got wet
during use. The system must be stored in its packaging in a cool, dry and ventilated room.
8