FITTING INSTRUCTIONS
Please take a few moments to read through these instructions. They cover fitting, us-
age, return information and answer many questions.
It is best to apply the JAS Ankle device while seated; you may sit or lie down to carry
out your JAS treatment sessions, but you should not be standing or walking. Your
doctor or therapist will determine if you should have your knee straight or bent while
performing your JAS therapy.
STEP 1:
ADJUST LENGTH OF FOOT PLATE
NOTE: This is a one-time adjustment and should be done at initial
JAS fitting by your therapist or JAS representative.
Align
STEP 2:
PLACE FOOT IN DEVICE AND ADJUST START ANGLE
ANKLE
Fig. 1 & 2
• Loosen screw on bottom
of foot plate.
• Place foot in device,
making sure heel is fully
back in device and
seated firmly in heel
Fig. 1
cup.
• Toes should not extend
beyond foot plate. The
axis for toe extension
should align across base
of toes, at the joint line.
• Slide forefoot piece to
adjust to proper length
and tighten screw.
Fig. 2
• Grasp and spread both
calf upright struts, and step
foot into device.
• Make sure heel is firmly
down and back in device,
with no heel lift or gapping.
• Rotate the ankle therapy
knob to adjust the device
angle until it matches your
comfortable position of
ankle motion.
STEP 3:
APPLY ANKLE STRAP
STEP 4:
SECURE VELCRO ON FOREFOOT
• Secure forefoot strap comfortably
• Secure strap across end of foot
• Feed calf straps through
D-rings, and secure
comfortably snug.
• Begin treatment protocol
by rotating therapy knob as
outlined on back of page.
• NOTE: Toe extension therapy
knob can be used to apply
a plantarfascia stretch.
• Remove ankle strap from
its velcro attachment on
side of device.
• Pull strap so that the white
pad is snug across front of
foot / ankle and secure
strap back on velcro tab.
• If necessary, adjust the
white pad by sliding it side
to side along the strap, so
that it is centered over the
front of the foot.
snug.
comfortably snug.
STEP 5:
SECURE CALF STRAPS
Rev 07/07