Care And Maintenance; Part List - Hauck METAL GLINDER Instrucciones Para El Uso

WARNING LABELS AND POINTS THAT NEED TO BE OBSERVED
GB
Read these instructions carefully before use and keep them safe
• Assemble this chair on a clean and non-abrasive surface.
• WARNING: Keep all plastic packaging materials out of the reach of
children, in order to avoid any risk of suffocation.
• Before use, check your chair for worn parts, torn material or stitching.
Replace or repair the parts when needed.
• Ensure all screws and parts are securely fixed before use.
MAINTENANCE
This chair is maintenance-free.

CARE AND MAINTENANCE

In General
Please check the chair function on a regular basis. Make sure that the frame is stable, the screws
are tight. Check the cover occasionally, making sure that the stitching is still firm, and inspect the
quality of the plastic parts. Any broken or worn working parts should be replaced immediately.
Proceed in the same manner with components that are broken, torn, defect or worn-out. Please
use only original hauck replacement parts.
Cleaning the covers
Remove the covers from the frame. Please read the instructions on the sewn-in label before
cleaning.
To clean the cover gently, wipe it down evenly using only a damp cloth. The cover should be
air-dried, but not exposed to excessive sunshine. Please do not dry the cover in the drier, to avoid
shrinking. Do not re-fit the covers until they are completely dried.
Cleaning the frame
Use only mild soapy water or lukewarm water to clean the frame of your stroller. Plastic parts can
be cleaned with mild detergent cleaners.
ASSEMBLY INSTRUCTIONS AND INSTRUCTIONS FOR USE

PART LIST:

a. Glider metal frame x 1 piece
b. Glider seat pad x 1 piece
c. Glider armrest pad x 2 pieces (left & right)
d. Footstool metal frame x 1 piece
e. Footstool cushion x 1 piece
f. Plastic washer x 2 pieces
g. Screw, size 6,3 mm x 32 mm x 4 pieces
h. Screw, size M8 x 63,5 mm x 2 pieces
i. Screw, size 6,3 mm x 15,9 mm x 4 pieces
j. Allen Key x 1 piece
INSTRUCTION OF USE
1. Connect the right and left armrest frames to the backrest of the chair by using 2 screws (h)
and 2 washers (f) (fig 1). You can fix the screws by using the provided Allen Key (j).
2. Insert the Glider seat pad (b) over the backrest of the Glider Frame (a). Attach the loop over
the notch on both sides (fig 2).
3. Position the armrest pad so that the holes in the armrest frame match the holes in the armrest
pad. From the underside, fasten each armrest by using 2 screws (g). Attach the loop of the
arm cushion over the rod on the side frame. Repeat for the opposite side. (fig. 3).
4. Attach footstool cushion (e) to footstool metal frame (d) by using 4 screws (i). Attach the loop
of the footstool cushion over the rod on the footstool frame.
4