Charge
Charging with the self-cleaning recharger
Thoroughly wipe off any drops of water on or around the
recharger so that it is dry before charging it.
3
2
1
Attach the detergent cartridge and the
1
water tank to the self-cleaning recharger.
Page 8
2
Insert the appliance plug.
2
3
3
Plug in the adaptor.
4
Remove the protective cap and then attach
4
the shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or damaged when
you are attaching the shaver.
•
The indicators on the LCD panel glow and charging starts.
•
If the indicators on the LCD panel do not glow, wait for a
short while until it glows.
•
Charging is completed when the indicators on the LCD panel
blink.
(Max. 1 hour later)
6
GB
4
•
You can keep the shaver attached to the recharger, or
connected to the adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
Charging without the recharger
You can also charge without the
recharger.
1. Insert the appliance plug into the
shaver.
2. Plug in the adaptor into a
household outlet.
LCD panel when charging
The LCD panel shows the remaining battery capacity from 0%
to 100%, in 10% increments.
After charging is
While charging
completed
The indicators
The indicators
blink once every
glow.
second.
2
1
10 minutes after
charging is
completed
The indicators
blink once every 2
seconds.