Urmet 1071/15 Manual Del Usuario página 7

- In 1-10V mode: max. current consumption:
10mA
• Four local buttons for direct output activation,
useful during system testing and/or configuration.
The corresponding output is set to the maximum
value when a button is pressed.
Mechanical characteristics
• Mechanical for 2-module bar
• Removable flap for accessing TERM bus terminal
and four buttons
• Dimensions: 36 x 58 x 90 m
[1.42 x 2.28 x 3.54 "]
• Max. wire section for terminals:
2
- 2.5 mm braided wire [AWG13]
2
- 4 mm one-pole wire [AWG11]
Logical characteristics
• Configurable with IPerSet software, via USB (see
1071/56).
• 254 possible logical addresses
• Possibility of defining the following for each single
output:
- 0-10V or 1-10V mode.
- linear or logarithmic behaviour.
- up to 13 steps to be used in multi-step mode.
- on or off delay for relays connected in series to
DS1071-009
the fluorescent light power
• Operation of each output for up to 37 events
(sensors or buttons)
• 49 possible logical actions for each output:
- 34 standard actions including: normal or slow
on/off, brief pressure memory and log pressure
variation, settings: prefixed brightness level
recall and multi-step mode,
variations, start/stop or retriggerable timer etc.
- Five inhibit actions from switch or button
- Five override actions to on in case of alarm
- Five override actions to off in case of higher
level hierarchic control.
brightness
7