Switch Clock Display; Alarm; View Alarm Settings; Set Alarm - Oregon Scientific BAR638HG Manual De Usuario

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.

ALARM

This product is equipped with a 2-minute crescendo
alarm.

VIEW ALARM SETTINGS

Press . The alarm time and alarm status will show in
the Clock Area.

SET ALARM

1. Press to switch to alarm display.
2. Press and hold again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press
settings. Press to confirm.

ACTIVATE ALARM

Press to activate or deactivate the alarm.
the Clock / Alarm Area when the alarm is activated.

SILENCE ALARM

When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:
• Press SNOOZE to silence it for 8 minutes.
OR
• Press any key except SNOOZE to mute the alarm and
activate it again after 24 hours.
If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.

WEATHER FORECAST

This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
SUNNY PARTLY
CLOUDY

TEMPERATURE AND HUMIDITY

This product can display current, minimum, and maximum
temperature and humidity percentage information
collected by the remote sensors and main (indoor) unit.
or to change
shows in
CLOUDY RAINY
Outdoor data is collected and displayed every 40 seconds.
Indoor data is collected and displayed every 10 seconds.

SELECT TEMPERATURE UNIT

° °
Slide the C / F switch into the desired location. The
switch is located in the main unit battery compartment.
The setting for the main unit overrides the remote sensor
setting.

SELECT CHANNEL NUMBER

Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
KINETIC-
WAVE
ICON
DESIG- Indoor
NATED Display
DISPLAY Channel 1 Channel 2 Channel 3
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEM.
NOTE If you use a sensor that collects only temperature
data, humidity will not be shown.
NOTE For more information on the sensor see "Remote
Sensor THGR122NX" section.

MINIMUM / MAXIMUM RECORDS

The MEM button is located in the main unit battery
compartment. Press MEM to toggle between current,
maximum (MAX) and minimum (MIN) records. To clear
the records, press and hold MEM for 2 seconds. A beep
will sound to confirm that the memory has been cleared.

MOON PHASE

The Calendar must be set for this feature to work, see
"Set Clock" section.
• Press or to view the moon phase for the next or
previous day.
• Press and hold
years (2001 to 2099).
New Moon
Waxing Crescent
First Quarter
Waxing Gibbous
Full Moon
Waning Gibbous
Last Quarter
Waning Crescent
6
Remote Remote Remote
Display Display Display
or to scan quickly through the