Ingco MG1309 Guia Del Usuario página 3

24. Keep work area clean.
Cluttered areas and benches invite injuries.
25. Remove adjusting keys and wrenches.
Form the habit of checking to see that
wrenches are removed from the tool before
turning it on.
26. Ensure that the abrasive product is
correctly mounted and tightened before use
and run the tool at no-load for 30 s in a safe
position, stop immediately if there is
considerable vibration or if other defects
are detected. If this condition occurs, check
the machine to determine the cause;
27Check that the work piece is properly
supported;
The wheel continues to rotate after the
28.
tool is switched off.
Inspect the grinding wheel before use,
29.
do not use chipped, cracked or otherwise
defective products;
SYMBOLS
Read the manual
Warning
Wear eye protection
Wear dust mask
Wear ear protection
Wear gloves
WEEE marking
3|English