Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO REPLACE BELT
Risk of Unsafe
Operations. Serious
injury or damage may occur if
parts of the body or loose items
get caught in moving parts. Never
operate the unit with the belt guard
removed. The belt guard should be
removed only when the compressor
is unplugged.
1.
Place the Auto/Off lever in the
"Off" position.
2.
Unplug compressor.
3.
Remove the front of the belt guard
by disengaging the snaps. Insert
a flat bladed screwdriver at each
snap location and pry the belt-
guard apart.
4.
Loosen the wing nut on hold
down plate and tilt motor to allow
for easy removal or installation of
the belt.
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2.
Set the Auto/Off lever to "Off" and
unplug unit.
3.
Turn the regulator counterclock-
wise and set the outlet pressure
to zero.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 PSI. Release safety valve ring.
6.
Drain water from air tank by
opening drain valve on bottom of
tank.
5.
Remove belt.
6.
Replace belt. NOTE: The belt
must be centered over the
grooves on the flywheel and motor
pulley.
7.
Turn the wing nut on the hold
down plate until it makes contact
with the washer, plus one addi-
tional turn.
8.
Replace the belt guard.
STORAGE
in the air tank. If not drained,
water will corrode and weaken
the air tank causing a risk of air
tank rupture and possible serious
personal injury.
7.
After the water has been drained,
close the drain or drain valve.
NOTE: If drain valve is plugged,
release all air pressure. The valve can
then be removed, cleaned, and rein-
stalled.
8.
Protect the electrical cord and air
hose from damage (such as being
stepped on or run over). Wind
them loosely around the com-
pressor handle. (If so equipped)
9.
Store the air compressor in a
clean and dry location.
23 - ENG
Wing Nut
Risk of Bursting.
Water will condense
N000578
Publicidad
Capítulos
Tabla de contenido
