Troubleshooting Guide - Lights of America 9700LED Serie Manual Del Usuario

symptOm pOssiBLe Cause
Lights will not come 1. Light switch is turned off.
on. 2. Lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new
6. Sensor is not aimed toward desired cover-
Lights come on in 1. Light control may be installed in a relatively
daylight.
2. Light control is in TEST.
Lights come on for no 1. Light control may be sensing small animals
apparent reason.
2. Range is set too high.
Lights stay on 1. The sensor may be picking up a heat source
continuously.
2. Sensor is in Manual Override mode.
Lights flash on and 1. Heat or light from the lamps may be turning
off.
2. Heat being reflected from other objects
3. Sensor is in the Test mode.
4. Light may be leaking through the flood
598-1360-00

trOuBLeshOOting guiDe

off.
installation.
age area.
dark location.
or automobile traffic.
like an air vent, dryer vent, or brightly
painted, heat-reflective surface.
the light control on and off.
may be affecting the sensor.
lamp reflectors
sOLutiOn
1. Turn light switch on.
2. Check lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
6. Re-aim sensor to cover desired area.
1. The fixture is operating normally under these
conditions.
2. Set control switch to 1, 5, or 10 minutes.
1. Reduce Range. Re-aim sensor.
2. Reduce Range.
1. Reduce Range. Re-aim sensor.
2. Set control switch to 1, 5, or 10 minutes.
Follow manual override instructions to reset.
1. Reposition the lamps away from the sensor.
2. Reduce Range. Re-aim sensor.
3. While in TEST mode, light only stays on for 5
seconds.
4. Make sure the metal lamp protectors are in-
stalled.
5