Product Features; Technical Data; Delivery Scope - Bosch PTA 2400 Manual Original

OBJ_BUCH-940-003.book Page 13 Friday, June 17, 2011 3:22 PM
Together with the power tool, the saw stand is intended for
the cutting to length of boards and profiles.

Product Features

The numbering of the product features refers to the illustra-
tion of the saw stand on the graphics pages.
1 Attachment set
2 Retaining adapter
3 Locking pin of the saw stand legs
4 Height-adjustable leg
5 Locking knob of the attachment set 1
6 Material stop
7 Locking knob of the length stop 6
8 Workpiece support
9 Locking knob of the workpiece support 8
10 Table extension
11 Locking pin of the table extension 10
12 Fastening kit, retaining adapter
13 Fastening kit, power tool
14 Lock nut
15 Fastening hole
16 Assembly-sliding plate
17 Locking knob of the table extension 10
18 Adjustment screw of the attachment set 1
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.

Technical Data

Saw stand
Article number
Length of saw stand without
table extension
Length of saw stand with table
extension
Height of saw stand
Max. carrying capacity
(power tool + workpiece)
without table extension
– Attachment set
Max. carrying capacity
(power tool + workpiece)
with table extension
– Attachment set
– Per table extension
Weight according to
EPTA-Procedure 01/2003
Bosch Power Tools
Assembly

Delivery Scope

No.
1
5
2
12
8
6
7
13
Additionally required tools (not in delivery scope):
PTA 2400 – Phillips screwdriver
– Spanner
3 603 M05 0..
Assembling the Saw Stand
mm 1220
– Carefully remove all parts included in the delivery from
their packaging.
mm 2440
– Remove all packaging material.
mm 820
Setting Up the Saw Stand (see figures A1 – A2)
– Lay the saw stand upside down on the floor (legs facing up-
ward).
– Push the locking pin 3 in and tilt the leg upward until the
kg 160
locking pin can be heard to engage.
– Repeat this workstep with the other three legs.
– Turn around the saw stand to the working position.
The manufacturer logo must face toward the front so that it
kg 110
can be read.
kg 25
– Ensure that the saw stand is stable and that all locking pins
have engaged.
kg 20.4
The saw stand is easily aligned with the height-adjustable leg
4.
– Loosen lock nut 14 and screw the leg in or out until the saw
stand is aligned level and all four legs face against the floor.
Please also observe the representation of
the delivery scope at the beginning of the op-
erating instructions.
Before assembling the saw stand, check if all
parts listed below are provided:
Designation
Saw stand PTA 2400
Attachment set
Locking knob of the attachment set
Retaining adapter
Retaining adapter fastening kit
consisting of:
– Assembly-sliding plate
– Hexagon bolt (M8 x 15)
– Washer
Workpiece support
Length stop
Locking knob of the length stop
Carriage bolt (M6 x 46)
Power tool fastening kit
consisting of:
– Hexagon bolt (M8 x 50)
– Washer
– Wing nut
1 609 929 T64 | (17.6.11)
English | 13
Quantity
1
2
2
2
4
4
4
2
2
2
2
4
8
4