Wiegand Output; Network - MyQ LiftMaster CAPAC Manual De Instalación

INTRODUCTION

Wiegand Output

NOTE: Disconnect power BEFORE making electrical connections.
The CAPAC will send the pre-assigned credential, configured via
myQ Community, to the TES via the Wiegand output.
GATE
1
SDA SCL NO COM NC
NOTE: For UL installations, only a Listed UL 294 access control
unit may be connected to Wiegand output 1 or 2.
PRE-INSTALL
OUTPUT WIEGAND INPUT
OUTPUT 2 1 WIEGAND 2
NO COM NC D1 COM D0 D1 COM D0
Third Party Access System Third Party Access System
Wiegand Input - TES / Wiegand Input - TES /
Access Control Wiegand Access Control Wiegand
INSTALL
Not responsible for conflicts between the information listed in
the wiring diagram and the requirements of your local building
codes. The information is for suggested use ONLY. Check your
local codes BEFORE installation.
INPUT POWER
1 GND 2 GND 12V-24V
POWER ETHERNET
14

NETWORK

ACCESS CONTROL