Dreame T30 Neo Manual Del Usuario página 10

Care & Maintenance
EN
3. Remove the pre-filter first, then lift the handle of the cyclone assembly and turn it counterclockwise
until it stops, then pull to lift out the cyclone assembly.
1
4. Wipe the dust cup with a soft wet cloth. Pay attention to wring out the discloth before using.
5. Rinse the cyclone assembly and pre-filter until they are clean. After washing, air dry for at least 24
hours .
Cyclone Assembly
Note: It is recommended to clean the pre-filter at least once every 3 months and the cyclone system at
least once every 6 months.
14
2
3
To avoid the risk of
electric shock, do not
rinse the dust cup with
water.
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Pre-filter
Care & Maintenance
Installing the Dust Cup, Pre-filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust cup, and make sure that the handle of the cyclone
assembly line up with the slot on the left side of the dust cup. Turn the handle clockwise until it locks,
then flip the handle down.
2. Place the pre-filter with its front side facing up into the cyclone assembly.
3
1
3. Slightly tilt the dust cup so its slot aligns with the clip on the vacuum. Then gently push the dust cup
until it clicks into place.
2
3
EN
15