How To Use - HoMedics UHE-WMTF185 Manual Del Usuario

HOW TO FILL
CAUTION: Before filling the tank with water, turn the power
NOTE: Always use 2 hands to carry the water tank.
TO FILL WITH A PITCHER
1. Remove the tank cover to 2. Fill the tank with cool (not
fill with a pitcher. cold) water until the water
level reaches the MAX fill
line.*
TO FILL AT THE FAUCET
1. To fill at the faucet, remove 2. Fill the tank with clean,
the tank cover. Remove the cool (not cold) water until
water tank. the water level reaches the
MAX fill line.*
*CAUTION: Never add essential oils or other additives to the water tank or water reservoir. Even a few
drops will damage the unit.
off and unplug the unit from the outlet.
3. Replace the tank cover.
3. Reassemble making sure
all parts are firmly seated.
6

HOW TO USE

CONTROL PANEL
CLEAN TRANSDUCER/
ULTRASONIC MEMBRANE
INDICATOR
WARM MIST SETTING
MIST OUTPUT SETTING
MIST OUTPUT
WARM MIST
NIGHT-LIGHT
POWER ON/OFF BUTTON AND OUT OF WATER INDICATOR
Plug unit into a 120-volt AC electrical outlet. Press the power
humidifier is out of water, the humidifer will turn off and the out of water indicator will illuminate on the
display.
MIST OUTPUT LEVEL
Mist adjusts from the lowest output to the highest output
the mist output button. The corresponding mist level will be lit on the display. Each press will increase
by one. Once you reach level 5, it will repeat at level 1.
WARM MIST SETTING
To change the mist temperature from cool to warm mist, press the warm mist
illuminated on the display. To change the mist temperature from warm to cool mist, press the warm mist
button again to turn warm mist off.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up the mist. The Warm
Mist function kills up to 99.99% of Escherichia Coli and Staphylococcus Aureus. Units were allowed to run
PROGRAMMABLE HUMIDITY/
CONTINUOUS ON SETTING
OUT OF WATER INDICATOR
AUTO-OFF TIMER SETTING
AUTO-OFF TIMER
PROGRAMMABLE
HUMIDISTAT
CLEAN TRANSDUCER/
ULTRASONIC MEMBRANE
POWER ON/OFF
button to turn unit on. When the
. To increase the mist output, press
button. will be
7