LUND 66903 Manual Del Usuario página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 65
GB
cause fi re and/or electric shock. The location for setting the device
should be chosen so that the steam jet can freely humidify the air
in the room. Warning! The steam outlet must not be obstructed. A
minimum of 0.5 m free space above the device must be maintained
so that the steam jet can escape freely. Select the location which
will ensure that the power cord does not pose a risk of tripping or
moving the device. When fi lling and cleaning the device, remove
the device's power plug. Fill the device's tank with cold water only
– water temperature should not exceed 35
C. Filling with hot water
O
can cause burns and deformation of the plastic tank. Do not use
fl ammable substances such as alcohols or solvents to fi ll the tank.
The device's tank should be fi lled so that the water level does not
exceed the maximum level marked on the tank wall. Overfi lling the
tank is forbidden. Only pure water or water mixed with a fragrance
may be poured into the tank. If fragrances are used, they must be
added to water outside the device, mixed and then poured into the
device's tank. Use only fragrances designed for ultrasonic devices.
The fragrances must be mixed with water in the proportions speci-
fi ed in the instructions accompanying the fragrance. Read the entire
content of the fragrance instructions before use. After each applica-
tion, unplug the power cord plug from the socket. Always disconnect
the device from the power supply, if it is left unattended, and before
putting it away, disassembling, cleaning or fi lling with water. Do not
leave the device unattended when it is connected to the power sup-
ply. Do not overload the power cord. Do not use the power cord to
carry the device, or connect or disconnect the plug from the socket.
Avoid any contact between the power cord and heat sources, oil,
sharp edges or moving parts. Damage to the power cord increases
the risk of an electric shock. If the power cord is damaged (e.g. it is
cut or its insulation is melted), immediately unplug it from the socket
and return the device to an authorised service facility. It is forbidden
13
O R I G I N A L
I N S T R U C T I O N S

Publicidad

Tabla de contenido
loading

Tabla de contenido