Monitor Programming - Fermax 1047 Manual De Instrucciones

KITS
VIDEOCONTROL
VIDEOCONTROL

MONITOR PROGRAMMING

After wiring up the equipment, and with the monitor plugged in, proceed as follows:
1
1.With the monitor connected, press the programming button. You will hear a confirmation tone.
2. Press the house call button. Confirmation tone is heard again.
* The monitor will not work until it has been programmed.
SELECTING THE CALL TONE
1
1.With the monitor connected, press the programming button. You will hear a confirmation tone.
2. Once in programming mode, press the «
tones. Each time the «
Once the call tone has been selected, leave the monitor on standby and, after 10 seconds, exit
programming mode.
< 2 min
» button is pressed, the selected tone is heard.
2
2
» button to sequentially select the available
Pag 17