Skil 2356 Instrucciones De Funcionamiento Y Seguridad página 22

SM 1619X07542 08-12_SM 1619X07542 08-12.qxp 8/27
Sliding Switch is pushed to the forward
position.
Push Sliding Switch forward to position bit,
selected for replacement, into Bit Holder for
removal. Move Forward/Reversing lever to
center position to activate trigger lock. Remove
bit by pulling outward on bit. In some cases, bit
may difficult to grasp and gloves may be
necessary. Insert new bit into bit holder. A
clicking sound will indicate that bit has made
proper contact with Magnetic Bit Holder. Note:
Only use ¼" hex shank bits which are 1" in
length.
FASTENING WITH SCREWS
The procedure shown in figure. 4 will enable
you to fasten materials together with your
Cordless Screwdriver without stripping,
splitting, or separating the material.
First, clamp the pieces together and drill the first
hole 2/3 the diameter of the screw. If the
material is soft, drill only 2/3 the proper length.
If it is hard, drill the entire length.
Second, unclamp the pieces and drill the
second hole the same diameter as the screw
shank in the first or top piece of wood.
Third, if a flat head screw is used, countersink
the hole to make the screw flush with the
surface. Then, simply apply even pressure when
driving the screw. The screw shank clearance
hole in the first piece allows the screw head to
pull the pieces tightly together.
22