Technical Data - Elite JS651 Manual De Usuario

jig saw to electrical outlets without pole contact to ground since the design meets class II safety.
Devices used in various loca�ons, including wet rooms and outdoors, must be connected through a residual
current device (FI, RCD, PRCD) of at least 30 mA.
Before performing any work with this machine, disconnect the power supply. Only plug in when the machine
is with the switch off.
Keep the power cord out of the working range of the machine. Always keep the network cable behind you.
Do not let any piece of metal enter the ven�la�on slots - There may be a danger of short circuit!
Under the effect of extreme electromagne�c interference from outside, temporary varia�ons of the rota�on
speed may occur in some par�cular cases.
MAINTENANCE
The ven�la�on slots of the machine must be kept clean at all �mes. If the power cord of this appliance is
damaged, it should be replaced only at a repair by authorized manufacturer center, to avoid dangerous situa-
�ons.
Use only authorized accessories and spare parts. If it is necessary to replace components that have not been
described, contact the nearest authorized service center.

Technical data

JS651
Power
Speed
Stroke distance
Cutting capacity
650W
3.000 r / min
19mm
Wood 55mm
Steel 6mm
Aluminum 10mm
JS750
Power
Speed
Stroke distance
Cutting capacity
750W
1.500 - 3.100r/min
23mm
Wood 105mm
Steel 10mm
Aluminum 20mm
8
Keep Working