Safety Precautions - Medical Depot Drive 2736723 Manual Del Usuario

assembly instructions
1. First remove all contents from carton: backrest,
handle with tube, rollator frame and basket.
2. Open frame by pushing down on sling seat on both
sides until the rollator is open all the way.
3. Turn the rollator upside down so both hand grips are
on the floor and the front and rear caster receptacles
are facing upwards.
4. Insert the back caster by inserting "A" into "B" with
the casters turned upwards (figure 1). The back caster
will be positioned properly when the brass release
buttons "click" through the frame.
5. Insert lock release knob (figure 2) to lock caster
assembly into place.
6. Repeat steps 4 and 5 to install other back caster.
7. To install front casters, insert caster leg into front
caster journal until a "snap" is heard (figure 3).
8. To adjust handle height, depress brass lock pin on
frame (figure 4) and either pull or push handle to
desired height. Be sure to repeat process for other
handle and ensure both lock pins are in the same
position.
1
A
3
2
B
4
1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from turning. If the wheels
turn while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should turn freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
6. Do not have anyone push you while you are sitting
back wards on the rollator. You can safely be pushed
only when you are sitting forward and you feet are
correctly positioned in the footrests.
Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a Temporary Stop — Pull
up slowly on the loop locks with four fingers until unit
slows down or comes to a temporary stop.
2. To Temporarily Lock Wheels in Position — Press down
on both loop locks with palms until you hear a "click"
that will tell you wheels are locked.
3. To Release Wheel Locks — Push up on both loop locks
with palms of hand to original position.
Lock Pin

safety precautions

loop lock operation