Publicidad
Idiomas disponibles
Idiomas disponibles
Continue For All Trucks
5. Press the bedliner firmly against the truck body. Center a
self-drilling screw in a pre-drilled hole in the bedliner. Fasten
the screw to the truck box wall with a power screwdriver
(See Figure 5). DO NOT OVER TIGHTEN BECAUSE THE
SCREW THREADS CAN BE STRIPPED EASILY.
6. (For all trucks) Repeat Step 5 to remaining hole location
on opposite side.
7. Install four (4) tie-down plugs into tie-down access holes
(See Figure 6). Install plugs by pressing around the outside
of the plug until seated. Rotate center attachment cord to
align the hole at the loose end of the cord with the pre-
drilled hole in the bedliner. Insert one push-in style fastener
through the hole at the loose end of the attachment cord and
into the pre-drilled hole in the bedliner. Press firmly into
place (See Figure 6).
8. Continue installing push-in style fasteners in tie-down covers
and into bedliner sidewalls until all tie-down access covers
have been completed.
Plug Removal
Use finger tab on plug for removal.
DO NOT USE THE TETHERS TO REMOVE PLUGS. DAMAGE
TO THE TETHERS AND FASTENERS MAY OCCUR.
FIGURE 5
PRE-DRILLED
SCREW HOLE
TRUCK BODY
SELF TAPPING
BEDLINER
FIGURE 6
FASTENER
Under Rail Bedliner
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
SELF TAPPING
SCREW
5/8"
3/4"
SCREW
PLASTIC
BEDLINER
METAL TRUCK BOX
PUSH-IN
STYLE
REVISION
FIGURE 6
TIE-DOWN ACCESS
HOLES IN BEDLINER
PRE-DRILLED HOLE
Tailgate Cover Installation
1. Remove the 2 existing factory installed screws from tailgate latch
plate.
2. Center plastic tailgate cover on truck tailgate.Insert and tighten
the two screws in the two center holes of tailgate.
3. Center a self-drilling screw in a pre-drilled hole in the tailgate
cover. Fasten the screw to the tailgate with a power screwdriver
(see Figure 7). Do not over tighten because the screw
threads can be stripped easily.
4. Repeat Step 3 to remaining hole locations until all are completed.
FIGURE 7
TAILGATE
LATCH SCREW
TAILGATE
COVER
SELF TAPPING
SCREW
5/8"
3/4"
PART NO.
REV 03MR08
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
PART NO.
19157519
6200 Grand Pointe Dr., Grand Blanc, MI 48439
TIE-DOWN PLUG
PUSH-IN STYLE FASTENER
TOP TWO TAILGATE
LATCH SCREWS
TRUCK TAILGATE
TOP SURFACE
TRUCK TAILGATE
PLASTIC TAILGATE
METAL TRUCK
TAILGATE
19157519
SHEET
Under Rail Bedliner
SHEET
PRE-DRILLED
HOLES IN
TAILGATE
COVER
COVER
2
6
OF
2
6
OF
Publicidad
