AIRONFLEX HI-POINT Serie Instrucciones De Montaje página 24

HI-POINT
Note that at steps 2 and 4, an emphasis to the locking of respective
pieces was given. Similarly, this fastening support set must be well
locked. Introduce in aperture (A) a Ø ½ fix key to detain movement of
the set previously assembled and screw piece (10) by hand until it is
firmly tighten.
After this assembling, when retaining by hand from the movement the
Ceiling support fastener (2) indicated at step 2, verify if the Fastening
support set is firm.
Every set that comes after this can rotate in this support pin (10), thus, it
must be sufficiently firm not to unscrew.
HI-POINT
FIXATION ON THE PROJECTOR
17
1
Place the nylon screw anchors
(14) according to the height of
each staff of the support and
select the screws (17) fastening
them to allow movement.
23
14
1
a
2
Move the central disc of the set in
order to place it over the gravity
center of the projector replacing
the staffs to a better esthetic
configuration inbound of the
projector. After this, firmly fasten
the fixation screws of these staffs.
17