Camera Setup; Activity Camera Setup - Dedicated Micros D4 Guía De Programación

Camera Setup

Camera Set-Up Title
Input termination
Camera type
Alarm input/Polarity
Colour adjust
Contrast adjust
Camera video input
Title
Each camera title can be up to 12 characters long.
Input termination
The input termination does not auto detect by default, the termination must be set
manually On (default) or Off. The termination must be set to Off if the camera is
looped through to other equipment.
Camera type
Colour and monochrome cameras are detected automatically, allowing colour/mono
switching cameras to be connected. The camera type can be manually configured
as Colour or Mono if necessary.
Alarm input/Polarity
Select whether the alarm connected is Normally open (default),
Normally closed, or Off.
Colour adjust
When the colour bar is selected, press
Note: this option is not displayed if the camera is set as monochrome.
Contrast adjust
When the contrast bar is selected, press down to reduce, and up to increase
the contrast.
Camera video input
This option is only displayed when a camera has failed or is offline. Select
disconnect whilst the camera is offline to prevent the camera fail message and
alarm being triggered.
Tip: This menu can be entered directly by pressing and holding a camera key.
18
CAMERA 1
Auto detect Off, On
Auto detect Off, On
Normally open Normally closed, Off
Connected Disconnected
to reduce, and to increase the colour.

Activity Camera Setup

Activity detection is used to record more images to disk from cameras that have
activity. The sensitivity of activity can be adjusted and areas can be masked off
according to the scene type.
Activity Camera Set-Up Detection Off
Sensitivity Outdoor high
Activity grid Setup
Activity test Walk test
Detection
Select whether activity detection is on or off for the selected camera.
Sensitivity
There are 5 levels of sensitivity for activity detection.
Select the sensitivity level which matches the camera's placing. Cameras sited
outdoors where there may be a lot of background movement, such as trees or
rain, should be set to Outdoor high or Outdoor low sensitivity. Cameras sited
indoors where there is very little background movement should be set to Indoor
high, Indoor low, or very low sensitivity.
Activity grid
An 8 x 16 grid is used to mask areas where activity detection is enabled. When
the grid is displayed, use the cursor keys to move the cursor to the desired
location and press a camera key to toggle the block on (white dot) or off.
Activity test
Use this option to test and tune the sensitivity and activity grid set up for each
camera. When activity is detected on the camera a white dot is displayed. Press
the mode/menu key to exit the test.
On
Outdoor low, very low, Indoor high, Indoor low