Daspi DS191 SW MV Funcionamiento página 18

WOLF SW MV: CONTROL BOARD FOR SWING GATES
DIGITAL PROGRAMMING OF MANEUVER TIME WITH THE COMMAND
1. - Record two buttons of the remote on the "RX MULTI" receiver on the control board. The first button
will be recorded in "CHANNEL 1" and will control the master gate. And the second button will be
recorded in "CHANNEL 2" and will control the slave gate.
2. - Once we have made step 1, press the "PROG TIME" button on the control board, the led will
remain fixed (programming is open).
3. - Press "BUTTON 1" of the remote the master door will begin to open. Wait for a time and press
"BUTTON 2", the slave door will begin to open.
4. -Press again the "BUTTON 1" to start the soft stop at the master door, and press "BUTTON 2" to start
the soft stop is slave door. (This function only works if the "SOFT STOP" option is activated (option 7).
5. - Press "BUTTON 1" again to finish the maneuver of opening in the master door and press "BUTTON 2"
to finish the maneuver of opening in the slave door.
6. - We will perform the closing maneuver by pressing "BUTTON 2" of the remote so that the slave door
begins to close. Wait for a time and press "BUTTON 1", the master door will begin to close
7. - Press again the "BUTTON 2" to start the soft stop in slave door, and press "BUTTON 2" to start soft stop
is master door. (This function only works if the "SOFT STOP" option is activated (option 7).
8. - Press the "BUTTON 2" again to finish the closing maneuver in the slave door and press "BUTTON 1" to
finish the master door closing maneuver.
If you use only one motor, make the programming process as if there were two motors.
PEDESTRIAN OPTION
This option will be done by recording on the channel 2 of the RX MULTI a button different from the
one selected to open the door. Each time we press this button we will open or close only the master
door. If both doors are open, this option does not work.
INSERT WIFI RECEIVER IN THE CONTROL PANEL
18