Parameter Menu; Fig. 15 - CARLO GAVAZZI EM112 Instrucciones De Instalacion Y Uso

Parameter menu

Fig. 15

To navigate in the menu, see "Commands" on page 4. Default values are underlined in the table.
Shared pages
Page Code
PASS P1 Enter current password
Change password
nPASS P2
Measurement type
MEASurE P3
Average power calculation interval
P int P4
(minutes)
MOdE P5 Display mode
Tariff management
tArIFF P6
HoME P7
Measurement page displayed when
turned on and after 120 seconds of disuse
Enable energy tariff, maximum requested
power, partial active energy and partial
rESET P13
reactive energy reset (the last two only
sent via serial port)
Return to the initial measurement page
End P14
Pages specific to the S1 version
Page Code
AddrESS P10
8021446 | EM112
Description
Description
Modbus address
Values
Current password.
Four digits (0000–9999)
A : easy connection , measures total energy
without considering the direction/ b: separately
measures imported and exported energy
1–30
Full : complete mode/ Easy : reduced mode.
Measurements not displayed are still sent via
serial port.
On: enabled/ Off: disabled
For full display mode (Mode = Full): 0–9/10
For reduced display mode (Mode = Easy): 0–3,
9/10
To learn the page code see "
menu" on page 6.
No: cancel reset/ Yes: enable reset
–
1-247
©2014 | CARLO GAVAZZI Controls SpA| 8
Measurement
Values