Publicidad
Idiomas disponibles
Idiomas disponibles
10
34. Disconnect connector C5, letter "E" labeled on the bottom of the TIPM. Release by depressing the locking tab and
rotating the connector arm outboard, until the connector is free from the TIPM assembly. Be certain to pull the
connector straight off.
35. Cut the P34 circuit TN/LB from cavity 7 (Right Rear Door Unlock Driver), using steps 38 through 43 solder in the
W/P tailgate wire.
36. Disconnect connector C6, letter "F" labeled on the bottom of the TIPM. Release by depressing the locking tab and
rotating the connector arm outboard, until the connector is free from the TIPM assembly (1). Be certain to pull the
connector straight off.
37. Cut the P38 circuit TN/LB from cavity 20 (Right Rear Door Lock Driver), using steps 38 through 43 solder in the W/P
tailgate wire.
Dec 01, 2011
2011 RAM
2011 RAM
K6869568 Rev. 3
Publicidad
