Enerpac IC-30 Hoja De Instrucciones

L2506 Rev A
Index:
English...............................................................1-3
Français.............................................................4-6
Deutsch .............................................................7-9
Italiano...........................................................10-12
Español .........................................................13-15
Nederlands....................................................16-18
Portuguese ...................................................19-21
........................................................22-24
Repair Parts Sheets for this product are available
from the Enerpac web site at www.enerpac.com, or
from your nearest Authorized Enerpac Service Center
or Enerpac Sales office.
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found, notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
personal injury or property damage during system
operation. Enerpac cannot be responsible for damage
or injury resulting from unsafe product use, lack of
maintenance or incorrect product and/or system
operation. Contact Enerpac when in doubt as to the
safety precautions and operations. If you have never
been trained on high-pressure hydraulic safety,
consult your distribution or service center for a free
Enerpac Hydraulic safety course.
Failure to comply with the following cautions and
warnings could cause equipment damage and
personal injury.
A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property.
A WARNING indicates a potential danger that
requires correct procedures or practices to avoid
personal injury.
A DANGER is only used when your action or lack of
action may cause serious injury or even death.
WARNING:
protective
hydraulic equipment.
®
06/02
Read all instructions, warnings
and cautions carefully. Follow
all safety precautions to avoid
Wear proper
gear when operating
IC-30, IC-31, IC-50, IC-51,
should never be used as a load holding device.
After the load has been raised or lowered, it must
always be blocked mechanically.
operation.
cylinder. Overloading causes equipment failure and
possible personal injury. The cylinders are
designed for a max. pressure of 350 bar [5,000 psi].
Do not connect a jack or cylinder to a pump with a
higher pressure rating.
may result in equipment damage and/or personal
injury.
the system to monitor operating pressure. It is your
window to what is happening in the system.
kinked hose will cause severe back-pressure.
Sharp bends and kinks will internally damage the
hose leading to premature hose failure.
pressure to a damaged hose may cause it to
personal
rupture.
Instruction Sheet
PSCK11, PSCK12
WARNING: Stay
supported by hydraulics. A cylinder,
when used as a load lifting device,
DANGER: To avoid personal injury
keep hands and feet away from
cylinder and
WARNING: Do not exceed equipment
ratings. Never attempt to lift a load
weighing more than the capacity of the
Never set the relief valve to a higher
pressure than the maximum rated
pressure of the pump. Higher settings
WARNING: The
pressure must not exceed the pressure
rating of the lowest rated component in
the system. Install pressure gauges in
CAUTION: Avoid damaging hydraulic
hose. Avoid sharp bends and kinks when
routing hydraulic hoses. Using a bent or
Do not drop heavy objects on hose. A
sharp impact may
damage to hose wire strands. Applying
clear of loads
workpiece during
system operating
cause internal