Publicidad
FAN AUTO
FAN TIMER
LIGHT TIMER
LIGHT DELAY
SET
TEMP./HOUR
GB
OPERATING THE TRANSMITTER
NOTE: In order to prevent damage to the transmitter, remove the battery when it is not in use over a long period of
time. If the low battery icon is flashing, change the battery as soon as possible.
1. Install 4 x AAA batteries (not included).
2. The Blue Fan Speed button allows you to change the fan speeds from OFF to HI to MED to
LOW and back to OFF manually.
3. Press the YELLOW button to turn the light ON/OFF.
4. Press the 2 arrow buttons marked "TEMP/SET/HOUR" to increase or decrease room
temperature setting and to set the number of hours that the fan or light will remain on when
the fan timer and/or light timer are used.
5. When the "Fan Auto" button is pressed, fan speed will be automatically set as below:
• When room temperature is lower than temperature setting, the fan speed will be
automatically turned OFF.
• When room temperature is 1°F higher than the temperature setting, the fan speed will
automatically be turned on LOW.
• When room temperature is 2°C or 4°F higher than temperature setting, the fan speed will
automatically be turned on MED.
• When room temperature is 4°C or 8°F higher than temperature setting, the fan speed will
automatically be turned on HI.
• In order to turn the "Fan Auto" function OFF, simply press this button again.
6. Press the "Light Delay" button to turn on the light. The light will automatically switch OFF
after 3 minutes. Press the YELLOW Light button in order to cancel the "Light Delay" function.
The "Light Timer" function will be cancelled when the "Light Delay" function is started.
7. Press the "Fan Timer" button to set the desired running time of the fan by using the "TEMP/
SET/HOUR" button for increasing/decreasing. The fan will automatically switch OFF when the
time is up. If the fan is set on "FAN AUTO" mode, it will be changed to Manual mode when
the time is up. When the "FAN TIMER" is ON, the display cycles between the "FAN TIMER" and
the "TEMP" setting. Time setting ranges are: 0.5, 1, 2...24 hours. NOTE: In Manual mode, set
the fan speed on HI, MED, or LOW by using the BLUE Fan Speed button before setting the
"FAN TIMER. "
8. Before setting the "LIGHT TIMER, " turn the light on by using the YELLOW light button. Press
the "LIGHT TIMER" button to set the desired time limit of light by using the "TEMP/SET/
HOUR" button for increasing/decreasing the amount of time desired. The light will automati
cally switch OFF when the time is up. When the "LIGHT TIMER" is ON, the display cycles be
tween "LIGHT TIMER" and the "TEMP" setting. NOTE: Time setting ranges are: 0.5, 1, 2...24
hours.
9. In order to set the temperature format to either Fahrenheit or Celsius, press through the hole
on the back of the transmitter with a ballpoint pen until the temperature displays the
desired format.
45
GS-26-77874-WH14
Publicidad
