Belkin TunePower Manual Del Usuario página 11

Charging the Belkin TunePower
Approximate charging times are as follows:
TunePower (whether connected to iPod video or not): 2 hours
Full-charge time: 4 hours
If the LED charge indicator flashes at any time during charging, a FAULT has occurred.
Simply disconnect the Belkin TunePower from the supplied cable for approximately
30 seconds, and reconnect the cable. Charging should begin automatically.
Notes:
The Belkin TunePower will supply power to the iPod video whenever it is connected.
When not in use, it is helpful to disconnect the Belkin TunePower from the iPod video
(recommended), or make sure that the iPod video is in the OFF and LOCKED position to
conserve power.
The iPod video can be charged at the same time as the Belkin TunePower. Doing so should
not increase the length of time that it takes to charge the iPod video.
The Belkin TunePower charging cable must limit its power consumption at times.
In some instances, the iPod video will have a higher charge current. At those times,
the charger will limit the amount of current going into the TunePower batteries, while
delivering full charge power to the iPod video. This increases the total charge time of
the TunePower to up to five hours.
EN
Charging the Belkin TunePower | 08
5095_A_ea_F8Z088ea_man.indd 8 8/9/2006 10:23:00 AM