Harman Kardon Go + Play Manual Del Usuario página 6

Symptom Possible.Problem
Charging/Syncing
iPod.will.not.charge. No.power.to.unit.
Wrong.adapter.is.used.
The.iPod.is.not.making.full.con-
tact.with.the.docking.station.
iPod.is.not.recognized Third-party.accessories.may.be.
by.the.computer.or.an.error.. conflicting.with.the.USB.signal.
message.appears.
USB.port.is.not.supplying.
enough.power.
Symptom Possible.Problem
Sound.Quality
Go.+.Play.emits.a.loud.hum.or. Input.cable.not.plugged.in.
buzzing.noise. properly.
Cable.may.be.bad.
Ground.loop.
Speaker.system.experiences. Input.cable.may.be.picking.up.
radio.frequency.interference.or. interference.
picks.up.a.radio.station.
Solution Note
Make.sure.wall.outlet.or.power.
strip.has.power..Make.sure.all.
switches.for.outlet/power.strip.
are.on.and.that.all.switches.for.
the.unit.are.on.
Make.sure.that.the.correct.
adapter.is.used.for.your.specific.
iPod.model.
Make.sure.that.the.iPod.is.
seated.securely.into.the.docking.
station.
Make.sure.you.do.not.have.the.
Go.+.Play.connected.to.a.USB.
hub.or.USB.device.
Connect.the.Go.+.Play.directly.
into.the.computer's.USB.port.
Try.connecting.the.USB.cable.to.
another.port.on.the.back.of.the.
computer.
Solution Note
Check.input.cable.connection.
Replace.cable..
Turn.the.Go.+.Play.off.and.con-
nect.it.to.another.wall.outlet.
Purchase.a.ferrite.core.and.wrap.
the.excess.cable.around.it..A.
ferrite.core.can.be.purchased.at.
your.local.electronics.store.
Technical.Specifications
Manufacturer:..
Model.Name:.
Available.in:.
Requirements:.
.
Drivers:.
Power:.
.
Frequency.Response:.
Dimensions:.
.
.
.
Input.Impedance:.
Signal-to-Noise.Ratio:.
Voltage:.
.

Harman.Kardon , Inc.
Go.+.Play ™
Black
iPod.with.docking.connector;
3.5mm.output.jack.for.other.devices
Two.Ridge.and.two.Atlas ™ .transducers
Tweeters:.2.x.30.watts.@.1%.THD
Woofers:.2.x.30.watts.@.1%.THD
40Hz.–.20kHz
Length:.20 .(500mm)
.
Width:.9 (230mm)
Height:.9.5 ..(240mm)
Weight:.3.9lb.(1.8kg)
>10K.ohms
>85dB
Input:.100-240V.AC.50/60Hz.2.0A
Output:.24V,.2.3A