Surface Burners (Cont.)
Top-of-Range Cookware
Aluminum: Medium-weight cookware is recommended
because it heats quickly and evenly. Most foods brown
evenly in an aluminum skillet. Use saucepans with tight-
fitting lids when cooking with minimum amounts of water.
Stainless Steel: This metal alone has poor heating
properties and is usually combined with copper,
aluminum or other metals for improved heat distribution.
Combination metal skillets usually work satisfactorily if
they are used with medium heat as the manufacturer
recommends.
Cast-Iron: If heated slowly, most skillets will give
satisfactory results.
Stove Top Grills
Do not use an after-market stove top grill on your gas
surface burners. A stove top grill will cause incomplete
combustion resulting in carbon monoxide levels above
allowable standards. This could be hazardous to your
health.
Using a Wok
Use only a flat-bottomed wok with a diameter of 14 inches
or less. Make sure the wok bottom sits flat on the grate.
Do not use a wok support ring. Placing the ring over the
burner or grate may cause the burner to work improperly,
resulting in carbon monoxide levels above allowable
standards. This could be hazardous to your health.
In Case of a Power Failure
In case of a power failure, you can light the surface
burners on your range with a match. Hold a lit match
to the burner ports, then slowly turn the control knob to
the LITE position. Use extreme caution when lighting
burners this way.
49-85209-6
Enamelware: Under some conditions, the enamel of some
cookware may melt. Follow cookware manufacturer's
recommendations for cooking methods.
Glass: There are two types of glass cookware—those
for oven use only and those for top-of-range cooking
(saucepans, coffee and teapots). Glass conducts heat
very slowly.
Heatproof Glass Ceramic: Can be used for either surface
or oven cooking. It conducts heat very slowly and cools very
slowly. Check cookware manufacturer's directions to be
sure it can be used on gas ranges.
Do not use stove top grills
Use a flat-bottomed wok.
Surface burners in use when an electrical power failure
occurs will continue to operate normally. If Lock Control
(on some models) is in use at the time of a power failure,
the surface burners cannot be lit.
11