Introduction; Programming The User Interface; Setting The Time And Day - Carrier Comfort Module Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54

Introduction

Carrier programmable user interface is a unit/wall--
mounted, low voltage device dedicated to control the room
comfort and the complete behaviour of the system installed.
A variety of features are provided including separate
heating/cooling set-points, virtual zone management,
system management, keypad lockout, backlighting, and
Note: the user interface will mount the front cover (lid) only in
case of wall installation.
Ignore references to lid in case of unit installation.

Programming the user interface

Setting the time and day

To set the time and day follow the steps below.
1.
Open the lid.
2.
Press D/H/M SET CLOCK ( ) button.
3.
Press the up or down button, to change the hour.
Stop on the correct hour.
4.
Press the D/H/M SET CLOCK ( ) button to set the
minutes.
5.
Press the up or down button to change the minutes.
Stop on the correct number.
6.
Press the D/H/M SET CLOCK ( ) button to set the day.
7.
Press the up or down button to change the day
Stop on the correct number.
8.
Press OK button or close the lid.
Note: Set the time only on master user interface or on user
interface connected to level 3 board. All the other user
interfaces will be automatically updated.
scheduling for all week days with 4 periods.
This manual covers usage, configuration and installation of
the user interface.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido