Publicidad
Step 19
Carefully turn your unit upright.
å
If the 109872 U-Shape Connector Kit was also purchased, go to that instruction book now. If the 109872 U-Shape
å
Connector Kit was not purchased, continue with this step.
With someone's help, carefully position the 109848 Return Kit next to the 109843 Executive Desk.
å
Fasten two CONNECTOR PLATES (T) to the bottom of the MOLDINGS on the 109848 Return Kit and 109843 Executive Desk.
å
Use sixteen BLACK 9/16" LARGE HEAD SCREWS (CC).
Fasten the 109843 Modesty Panel to the 109843 Inner End. Use three BROWN 1-1/2" FLAT HEAD SCREWS (14S) and
å
FINISHING WASHERS (X).
Fasten the SUPPORT BRACKET (Q) (already attached to the 109843 Modesty Panel) to the 109843 Front Molding. Use
å
three BLACK 9/16" LARGE HEAD SCREWS (CC).
NOTE: The Front Molding has two pre-drilled holes for the SUPPORT BRACKET. There is no pre-drilled hole for the third
å
SCREW. Use a little extra force when starting this SCREW.
IMPORTANT: The 9848-015 Return Kit must be attached to the 109843 Executive Desk as indicated in this step.
å
Go to the last step now.
å
If you're doing this to
help a friend, don't
leave without a bite.
www.sauder.com/services
RETURN KIT(S) ON RIGHT
(3 used)
X
14S
BROWN 1-1/2" FLAT HEAD SCREW
(3 used in this step)
109848
BLACK 9/16" LARGE HEAD SCREW
(19 used for the PLATES and BRACKET)
T
1 0
9 8
C
M o
4 3
d e
P a
s t y
n e
l
CC
Page 23
Publicidad
