Resumen de contenidos para Dorel Home Products DA3729
Página 1
You can also chat with us at www.dhpfurniture.com Date of Purchase Lot Number (TAKEN FROM CARTON) THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. C.W. - 2021/7/6 B34DA372900-241637-C 2020 Dorel Home Products All Rights Reserved...
Página 2
Limited 1 year Warranty Read Before Beginning Assembly Dorel warrants this product to be free from defects in material and workmanship Work in a spacious area and near where the unit will be used, preferably on a and agrees to remedy any such defect. This warranty covers one year from the carpet, or use a piece of the cardboard packaging to protect your floor and product.
PARTS LIST Back Frame Stretcher Left Chair Leg Right Chair Leg Chair Front Rail 2 PCS 2 PCS 2 PCS 2 PCS 2 PCS Table Rail Side Frame Right Side Panel Seat Cushion Left Side Panel 2 PCS 1 PC 1 PC 1 PC 2 PCS...
Hardware Pack Hardware Pack Please do not completely tighten all the hardware, until the entire assembly is complete, unless otherwise indicated in the step-by-step instructions. DA3729(Black) HP#: TDA3729A-00 The screw(s), bolt(s) to be used at each step are DA3729W(White) HP#: TDA3729W-00 shown in actual size in the lower right corner of the page.
Página 7
Hardware Pack Please do not completely tighten all the hardware, until the entire assembly is complete, unless otherwise indicated in the step-by-step instructions. DA3729(Black) HP#: TDA3729B-00 The screw(s), bolt(s) to be used at each step are DA3729W(White) shown in actual size in the lower right corner of the...
Página 8
This illustration shows how the CAM fastening system works.
Página 9
Step 1 Attach the right and left chair legs B & C to the back frame A with bolts NOTE: Bracket on B and C must be oriented towards the opposite direction as indicated. NOTE: Do not fully tighten the bolts, Loose bolts will facilitate assembly in the following steps.
Página 10
Step 2 Attach stretcher D to the back frame A, right and left chair legs B & C with bolts NOTE: Do not fully tighten the bolts, Loose bolts will facilitate assembly in the following steps. NOTE: The short end of Part D must be attach with Part A as show below.
Página 11
Step 3 Attach the chair front rail E to the chair legs B & C with bolts Tighten all bolts previously installed in step 1~3. NOTE: The narrow width of Part E must be oriented towards Part A as show below.
Página 12
Step 4 Attach the seat cushion F to the chair with wood screws using a Phillips head screw driver (not included). You've finished assembling your Chairs! NOTE: The narrow width of Part F must be oriented towards Part A as show below.
Página 13
Step 5 Screw cam bolts into the holes of side panel I & J, upper rail K, lower rail L, back panel M, and table top O. X 42...
Página 14
Step 6 Insert cam locks into the holes of shelf panel N. UNLOCK LOCK Attach lower rail L to shelf panel N by turning DESAPRETAR APRETAR OUVRIR SERRURE cam locks with Phillips headed screw driver(Not included). Repeat the same assembly above to attach upper rail K x 2 to shelf panel N x 2.
Página 15
Step 7 Insert the cam locks into the holes of the shelf panel N. Attach shelf panel N to the back panel M as shown above. then turn the cam locks to lock. UNLOCK LOCK DESAPRETAR APRETAR OUVRIR SERRURE NOTE:To avoid fraying the surface of part, please lay the surface of part on a piece of carpet or carton board.
Página 16
Step 8 Insert the cam locks into the holes of the UNLOCK LOCK shelf panel N x 3, back panel M, DESAPRETAR APRETAR OUVRIR SERRURE lower rail L, and upper rail K x 2. Attach the side panels I & J to the subassembly as shown.
Página 17
Step 9 Attach the table rails G x 2 to the side frame H and the subassembly obtained in previous step using bolts as shown. NOTE: Holes on H must be oriented upwards as indicated.
Página 18
Step 10 Attach table top O to left side panel J, back panel M and right side panel I by turning cam lock Attach table top O to side frame H using bolt UNLOCK LOCK DESAPRETAR APRETAR OUVRIR SERRURE...
Página 19
Step 11 Attach hook x 2 to left side panel J with screw...
NOT use harsh chemicals or abrasive cleaners. Some parts have been pre-assembled for this item. They are illustrated on this page and available for replacement. Check bolts and nuts periodically and tighten if necessary. End Cap DA3729(Black) T919100 DA3729W(White) T919400 End Cap DA3729(Black) T392490...
DA3729(Negro), DA3729W(Blanco) NO LO REGRESE A LA TIENDA! Si le faltan piezas o las que se incluyen est n da adas, con mucho gusto le enviaremos sus piezas de reemplazo sin cargo extra. Juego de bar de 3 piezas con sillas Visite www.dhpfurniture.com/spa/replacement-parts...
Partes Paquete de componentes # de Paquete :DA3729(Negro): TDA3729A-00, TDA3729B-00 Piezas de reemplazo, visite www.dhpfurniture.com/spa/replacement-parts DA3729W(Blanco):TDA3729W-00, TDA3729B-00 IMPORTANTE: La lista de n meros de piezas que aparece a continuaci n es Nota: Por favor no apriete completamente los pernos hasta que el exclusiva de su producto.
Instrucciones Esta ilustraci n muestra c mo funciona el sistema de fijaci n de leva. Paso 10 Una la parte O con J, M & I con Paso 1 Una la parte O con H con Una la parte B & C con A con Paso 11 Paso 2 Una la parte...
DA3729(Noir), DA3729W(Blanc) NE PAS RETOURNER CE PRODUIT AU MAGASIN ! Si une pi ce est manquante ou endommag e, nous vous exp dierons avec plaisir vos pi ces de remplacement Ensemble table-bar 3 pi ces hauteur gratuitement. Visitez www.dhpfurniture.com/fre/replacement-parts comptoir avec chaises...
Página 25
Pi ces Quincaillerie Pour des pi ces de rechange, visitez www.dhpfurniture.com/fre/replacement-parts # de paquet : DA3729(Noir): TDA3729A-00, TDA3729B-00 DA3729W(Blanc):TDA3729W-00 , TDA3729B-00 IMPORTANT: La liste des r f rences ci-dessous est propre votre produit. Veuillez l'avoir sous la main lorsque vous appelez pour des pi ces de rechange.
Instructions Cette illustration montre le fonctionnement du syst me de fixation CAM. tape 10 Attacher O J, M & I avec tape 1 Attacher B & C A avec Attacher O H avec tape 2 tape 11 Attacher D A, B & C avec Attacher J avec tape 3...