Desa PowerFast 32003 Instrucciones De Operación página 6

4. Insert nails into nail channel
through rear of nail chamber (see
Figure 4). Make sure nail points
are towards bottom of tool.
Note: We recommend that you
only use PowerFast
in this tool. Wrong brad nails can
cause jamming.
5. Replace nail pusher into nail
chamber. Do this by inserting flat
metal end of nail pusher into nail
channel (see Figure 5). Fully
push nail pusher into nail cham-
ber. Push hook end of nail pusher
up and latch it to nail chamber.
Operating Tool
WARNING: Keep trigger lock in the OFF position and finger off
trigger until ready to drive nail.
WARNING: Keep all body parts away from nail exit opening on
tool.
1. Make sure trigger lock is in the OFF po-
sition.
2. Plug tool into a 115 Volt/60 Hertz outlet.
3. Grip tool firmly and hold against work
surface. Use enough pressure to de-
press safety lock. The safety lock is lo-
cated on nail exit of tool (see Figure 6).
IMPORTANT: The safety lock must be
depressed for this tool to operate. This
tool will not fire unless this is done.
4. Slide trigger lock to the ON position.
www.desatech.com
®
brad nails
6
Nail Channel
Brad Nails
Figure 4
Figure 5
Nail Channel
Safety Lock
Figure 6
101647