How To Use - Moulinex POWERSTYLE Manual Del Usuario

- Do not use the appliance to suck up hot residues (cinders,
ashes etc.)
- Never suck up water or any other liquid or damp substances
(e.g. still damp carpet cleaning foam ) or sharp objects.

How to Use

Fold out the cover page of this leaflet. The numbers corres-
pond to the descriptions of the various parts and functions
described on the following pages.
. Assembling the tubes
1
- Fit the two tubes together (H1) or (H2).
. If your appliance is equipped with a telescopic tube with
2
ratchet system (H3) :
- Push the slide switch and adjust the tube to the required
length.
- Release the slide switch : the tube will be locked in place.
- To unlock the tube push the slide switch again : the 2 sections
will slide apart.
. Attaching the flexible hose to the vacuum cleaner
3
- Push the end of the pivoting head on the flexible hose (G1)
into the attachment point on the vacuum cleaner.
To remove the flexible hose from the vacuum cleaner : press
on the two buttons situated on either side of the pivoting head,
then pull upwards to remove it from the attachment point.
. Fitting the large cleaning tool
- Fit the large cleaning tool onto the end of the tubes.
a. If your appliance is equipped with an automatic cleaning
4
tool (I1).
This new cleaning tool automatically adapts to the type of
floor to be cleaned.It is very easy to use due to its system of
large roller wheels.
5
b. If your vacuum cleaner is equipped with a 2 position
cleaning tool (I2)
- Your 2 position tool (I2) has a rocker switch which allows you
to alter the position of the brush according to the type of floor
to be cleaned
. Hard floor position ( tiles, parquet floors...) : The cleaning
tool's brush must be in the lower position. Press on the rocker
switch to lower it.
. Carpet or rug position
The cleaning tool's brush should be raised. Press the rocker
switch to lift the brush up. Only the flat part of the tool is in
contact with the floor.
. How to plug in and use
6
- Pull the mains lead out to the desired length and plug in the
appliance.
- Press pedal (A1) to start the vacuum cleaner.
To stop it press the pedal again.
. Adjusting the power level
7
. If your appliance is equipped with an electronic variable
power control (B2) you can choose the power appropriate for
the task.
17