Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
System Model Number
Nominal Diameter (in.)
Nominal Impedance (Ohms)
Frequency Response
Fs (Hz)
Sensitivity (SPL@1w/1m)
RMS Power Handling* (Watts)
(Continuous)
RMS Power Handling* (Watts)
(Maximum)
Mounting Diameter (in.)
Mounting Diameter (mm)
Mounting Depth (in.)
Mounting Depth (mm)
* Rated Power Handling for the overall system
Specifications subject to change without notice
Mounting Location
• Place the speakers where they have a direct path to the listening area.
• Whenever possible, place the tweeter directly above or below
the midrange as this maximizes the imaging (point source)
capability of the speakers.
Installation — English
1. Cut the proper size hole for the midrange speaker;
• For the 5-1⁄4" speaker, cut a 117.5mm (4-5/8") diameter hole.
• For the 6-1⁄2" speaker, cut a 143.0mm (5-5/8") diameter hole.
2. Place the speaker frame over the mounting hole and mark the location of the
screw mounting holes.
3. Remove the frame. Drill the holes for the screws using a 1/8" drill bit.
Mounting Tweeter
• Decide which mounting method to use for the tweeter.
Flush Mounting
• Cut a 47mm (1-13/16") diameter hole.
• Route wires and mount tweeter into housing.
• Use clips to mount tweeter and housing into place
2
STRIKE COMPONENT SPEAKERS
S4.525C
S4.65C
5.25
6.5
4
4
60Hz–20kHz
55Hz–20kHz
60
55
85dB
85dB
50
50
100
100
4-5/8
5-5/8
117.5
143.0
2-3/8
2-1/2
60.3
63.5
Check our website www.LightningAudio.com
for updates on your products.
Model
Nominal Diameter (in.)
Nominal Impedance (
Frequency Response
Fs (kHz)
Sensitivity (SPL@1w/1m)
RMS Power Handling
Mounting Diameter (in.)
Mounting Depth (in.)
* Power Rating is established with
recommended filter network
Model
Crossover Type
Crossover Frequency
Crossover Slope
Filter Q
Tweeter Protection
Dimensions in Inches
(Width x Depth x Height)
Tweeter
Mounts
2-5/32"
(54.36mm)
2-1/16"
(51.82mm)
Tweeter
1.0
)
4
2.5kHz–20kHz
2.5
90dB
50 Watts*
See Drawings
See Drawings
Crossover
2-Way
4kHz @ 4ohms
12dB/octave High-Pass
12dB/octave Low-Pass
0.707 (Butterworth)
Optical Compression
4-5/8 x 4-1/8 x 1-1/2
21/32"
(16.26mm)
1-13/16"
(46.23mm)
FLUSH
3/4"
(19.05mm)
SURFACE
Publicidad
