Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
AX-ADGM02
GM LAN 11 vehicles 2006-2012
The AX-ADGM02 is designed to and must be used with the AX-ADBOX1 or
AX-ADBOX2 (sold seperately). Please refer to AX-ADBOX1 or AX-ADBOX2
for 16-pin connector instructions.
applIcatIons
cHeVrolet
Cobalt
HHR
Malibu
pontIac
G5
G6
Solstice
saturn
Aura
Sky
Interface components
• 22-pin to 30-pin GM harness • 4-pin to 4-pin resistor pad harness
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.
Installation Instructions for AX-ADGM02
2007-2011
2006-2011
2008-2012
2007-2008
2009-2010
2006-2009
2006-2009
2006-2009
™
1-800-221-0932
Caution, Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
InstallInG tHe Interface
from the 16-pin harness with stripped leads (included with interface)
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of
the aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of
the aftermarket radio.
• The Green wire is not used in this application.
• The Green/Black wire is not used in this application.
• The purple wire is not used in this application.
• The purple/Black wire is not used in this application.
from the 22-way harness:
The Black/Yellow wire will be discussed later on in the instructions.
The DIN plug is to be connected to the optional XIA-LCD screen if satellite is being retained.
from the 30-way harness:
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the RCA's to the AUX in on the aftermarket radio (if equipped).
• Connect the Yellow wire to the constant wire of the aftermarket radio.
If the vehicle is amplified disconnect the 4-pin harness located between the
30-way and 22-way connector and connect the supplied 4-pin to 4-pin resistor pad. If the
vehicle is not amplified connect the two 4-pins for the 30- and 22-way together.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Publicidad
Manuales relacionados para Metra AX-ADGM02
Resumen de contenidos para Metra AX-ADGM02
- Página 1 All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. The AX-ADGM02 is designed to and must be used with the AX-ADBOX1 or InstallInG tHe Interface AX-ADBOX2 (sold seperately).
- Página 2 AX-ADGM02 InstallInG tHe Interface testing the aX-adGm02 (continued) Turn the ignition on, and then turn the aftermarket radio on. amplified vehicles: Push the OnStar button, the radio should turn off (radio will mute if mute wire is • Connect the Violet wire to the right rear positive wire of the aftermarket radio.
- Página 3 El AX-ADGM02 está diseñado y deBe utilizarse con el AX-ADBOX1 o AX- ADBOX2 (SE VENDE POR SEPARADO). Consulte el AX-ADBOX1 o AX-ADBOX2 instalaCión de la interfase...
- Página 4 AX-ADGM02 instalaCión de la interfase prueba de aX-adGm02 (continued) Abra la llave y luego encienda el radio de mercado secundario. Vehículos amplificados: Presione el botón OnStar, el radio debe apagarse (el radio se quedará en silencio • Conecte el cable violeta al cable positivo posterior del radio de mercado secundario si el cable de silencio está...