HomeNetWerks 7130-08-BT Manual Del Usuario página 9

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
2. Measure the opening to ensure it is large
enough to accommodate the new fan housing
$  LQ [  LQ 
3. If this fan is not replacing an old fan, be sure
WR FXW D  LQ [  LQ RSHQLQJ IRU WKH
IDQ KRXVLQJ $ 
 Place the fan housing next to a ceiling joist or
wall stud. The fan housing should be level and
perpendicular to the joist or stud. Allow for thick-
ness of ceiling board used in your application.
'2 127 ÀXVK PRXQW WR MRLVW %RWWRP RI WKH IDQ
KRXVLQJ VKRXOG EH ÀXVK ZLWK FHLOLQJ ERDUG
5. Before mounting the fan housing to the joist,
remove the plastic duct connector for easier
access to the mounting hole on the fan housing.
5HPRYH WKH GXFW FRQQHFWRU E\ LQVHUWLQJ D ÀDW
head screw driver between the plastic and metal
of the fan housing, then GENTLY pry the duct
connector off.
www.homewerksww.com
2
3
4
5
9