Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
- Open the radio receiver's casing, removing the screws (see Fig. 3);
- Prepare the frame and holder for the passage of the cables, according to the type of installation (ver-
tical or wall mounted);
- Install the holder, using the vertical fastening or wall mounted points;
- Remove the terminal from the circuit and make all the necessary connections to the terminal, follo-
wing the instructions given in Fig. 2; then reinsert the terminal;
- Secure the receiver to the holder, using the 3 self-tapping screws and O-rings supplied, then move on
to the memorization phase on the radio control (see following paragraph);
- Close the casing, making certain the slots line up correctly, then tighten the body using the relative
screw;
- Set the O-ring on the grub screw, as indicated in Fig. 3, then screw on the antenna completely.
FASTENING
SCREW
PROGRAMMING AND OPERATING MODES.
The "RX2" radio receiver can support an input of 146 codes, which can be used on its two avai-
lable channels.
Channel CN1 is set for monostable operation only, whereas channel CN2 offers 4 different ope-
rating modes that can be selected using the switch (see Table 1, Fig.4).
If no remote control has been memorised, both LEDs will remain off; the condition LED "ON" indica-
tes that at least one remote control has been memorised on the corresponding channel.
8
TERMINAL
SLOTS
HOLDER FASTENING
SCREWS
Tab. 1. Functioning of the channel CN2 based on all
ANTENNA
O-RING
O-RING
GRUB SCREW
VERTICAL MOUNT HOLES
Operation
SW1 position
Monostable
OFF
Temp. 25 s
ON
Temp. 50 s
OFF
Bistable
ON
possible combinations of the switch.
WALL MOUNT HOLES
HOLDER
SW2 position
OFF
OFF
ON
ON
Publicidad
Tabla de contenido
