Wall Mounting - Snom PA1 Manual Del Usuario

Wall mounting

Note: The Ethernet cable must not be bent to avoid damage and loss of
the network connection. We recommend that you place the PA1so that the
PoE connector is facing toward the LAN port in your network.
1. Use the measurements in Fig. B on page 2 to mark the positions of the
four holes to be drilled in the wall.
2. Drill the holes and insert the expansion anchors in the holes.
3. Place the snom PA1on the wall with the cut-outs above the anchors as
shown in Fig. C on page 3.
4. Place the screws in the anchors and tighten them evenly.
Connecting
See Fig. D on page 3.
For more information on connecting the snom PA1 and
for information on setting it up and operating it, please
refer to the manual available on the snom PA1 product
page at www.snom.com.
  
snom PA1 Quick Start Guide
E
N
G
L
I
S
H
9