ERA PRO TYPHOON Serie Manual De Mantenimiento página 11

4
Installation instructions for the speed switch button:
1. Remove the cover with a wide flat screwdriver. To do this, insert a screwdriver into the groove of the plug on the terminal
box casing and knock out the plug with a sharp blow.
2. Install the button in the drilled hole.
3. Connect, according to the diagram using RPI-M(n) 1.5-6.3 connectors (3 pcs., not included). To connect, it is necessary to
bring the wires into flat connectors and clamp them with a crimping tool. You can also connect the contacts in other safe
ways: by twisting, soldering, and welding.
ATTENTION!
By installing the speed switch button, the protection level is reduced to IP42.
Wiring connection diagram for models with flange
diameter 100-200 (for fans without speed switch button)
Wiring connection diagram for models with flange
diameter 250, 315 (for fans without speed switch button)
5
TYPHOON wiring connection diagram
N
(Neutral)
Figure 2.
N
(Neutral)
Figure 3.
Wiring connection diagram for models with flange
diameter 100-200 (for fans with speed switch button)
Wiring connection diagram for models with flange
diameter 250, 315 (for fans with speed switch button)
EN
N
(Neutral)
N
(Neutral)
11